You are here: Home » News Center » Laser Machine News » About Laser Cutting Acrylic

About Laser Cutting Acrylic

Publish Time: 2023-05-19     Origin: Site

Acrylic is one of the most essential and popular materials to work with in the awards and engraving industry. It can also be one of the most difficult. The process from sheet stock to finished award is a long one, but with the right settings on your equipment, you can create beautiful finished acrylic pieces that are perfect for various applications.

Prepping the acrylic and laser

Determining the settings

Typically, acrylic comes from the factory or supplier with a protective carrier sheet to reduce damage and scratching. You can leave this on while cutting or remove it right before cutting. By leaving it on, you reduce the amount of smoke that can land on the surface of the acrylic, potentially causing a haze, and protect the acrylic from scratches.

To prep the laser for cutting, use your air assist and a honeycomb laser bed. The air assist is essential to help push the acrylic fumes through your cut, and the honeycomb table helps reduce flashback and aids in pulling the flammable fumes out of your laser.

When determining your laser cutting settings, the best place to start is with the laser manufacturer’s recommended settings, then adjust from there to optimize your cuts. The three variables to adjust are speed, power, and frequency—these change depending on your laser wattage.

In general, as the thickness of the acrylic you cut increases, the cutting speed must decrease. ARGUS also recommends two passes for the thicker 3/8″ acrylic. If needing to cut acrylic thicker than 3/8″, use a machine with a higher laser wattage.


Argus Laser, your professional 
laser solutions supplier since 1998 !!!
 

Get In Touch

  Address: NO.4 Huanglong Shan North Road, East Lake High-tech District, Wuhan City, China
  Cel/whatsapp/wechat: :+86-15927005027
  E-mail: suniclaser@sunic.com.cn

Contact Us

Copyright   Wuhan Sunic Photoelectricity Equipment Manufacture Co.,LTD. Supported by Leadong